The adhesive is cheap and needed to be rrplaced by actual 3M stuff. Overall good product, but suggest replacing the adhesive before installation
Installed easily, but doesnt have the two guide pins to tell which way is up/down
B9 Allroad — RS Grille Modification Guide
This is the official Enthusiast Brands install guide for fitting our RS-style honeycomb grille onto the B9 Allroad. The process requires three permanent modifications to the grille frame so it seats correctly against the Allroad bumper opening.
Read the full guide before purchasing to make sure you're comfortable with the modifications. The grille is otherwise OEM-fitment for A4/S4 B9 — only the Allroad needs these adjustments.
What's covered in the guide
- Remove lower corners of the grille — trim the lower-corner mounting tabs from each side.
- Cut lower bottom tabs — remove the row of locating tabs along the bottom edge.
- Trim upper locking tabs — reduce each upper tab by 1/8" for proper fitment.
Each step includes annotated before/after photos. Use a rotary cutter on a low setting and test-fit between cuts.
If the embed above doesn't load in your browser, use the download button at the top of the page.